Product List

Perimeter Seals
Thresholds
Automatic Drop Seals
Perimeter Brush Seals
Perimeter TPE Seals

Seal Systems

DSA Class 37 STC-Rw
DS-44 Head and Jamb Seal
Page 8 Page 9 

DSA Class 44 STC-Rw
DS10-47 SB Head and Jamb Seal
Page 10 Page 11

DSA Class 34 STC-Rw
DS10-R Head and Jamb Seal
Page 12 Page 13

DSA Class 44 STC-Rw
DS20-24 Head and Jamb Seal
Page 14 Page 15

DSA Class 47 STC-Rw
DS20-24 Head and Jamb Seal
Page 16 Page 17

DSA Class 34 STC-Rw
DS12-150 Wing Seal
Page 18 Page 19

DSA Class 33 STC-Rw
Sliding Doors
Page 20 Page 21

DSA Door Systems
Full Diagrams
Page 26 Page 27

Fire & Acoustic Data
Page 4 Page 6 Page 7
Noise Definitions
Acoustic System
DSA Certificate of Assessment

Water Penetration Tests
Page 22 Page 23
Page 24 Page 25

Installation & Welding Equipment
Aluminium Door Frames

Email:
sales@doorseals.com.au

Phone: +617 3856 6660
Fax: +617 3352 7488

ABN: 67 528 663 992

Undoubtedly the most important part of any seal application is finding the right seal for the job. Our research has shown that the four most common criteria used to select door and window seals and extrusions are performance, aesthetics, ease of installation and value.

Performance specifications vary for each of our products depending on the application for which it is used, and our prices speak for themselves. This section has been designed to demonstrate the remaining two criteria, aesthetics and ease of installation, as they apply to two of our products.

For further enquiries with regards to our products or the installation thereof, please click here to contact us.

DS10-47
DS20-24
DS10-R

Using our installation system guarantees your seals will work correctly.

Please note - measurements will need to take into account paint or veneer finish on doors.

Fix door and latch first. Pull the seal from the extrusion. Measure and cut to size. Make sure the extrusion is separated from its cover (see figure 2). Use 3.5mm packing between door face and aluminium extrusion. (If using DS20 with S6577 seal use 4.5mm packing). Then:

1. Screw DS10 / DS20 aluminium extrusion to door jamb through the pre-punched holes.

2. Snap DS10 / DS20 using the method illustrated in figure 3.

	3. Feed S6620 into face of extrusion and trim off ends with scissors.

home - about the company - catalogue download - installation tips - general information - online catalogue

All text, images and content on this site is Copyright 2003-2006 Door Seals of Australia. Reproduction is by written permission only and must accompany the Door Seals of Australia brand and copyright notice.